To read and write or validate some or all of the data, follow these steps below:
1. Plug up the Store device of EZ Program into port 2 of the PLC CPU VersaMax. The LED of device switches green after approximately 2 seconds. The interruption lets time for correct seating of the tool.
2. If the PLC is in mode of Run when the Store device of EZ Program is linked, the LED Run on the PLC flickers at a 1 Hz rate.
3. If the Store device of EZ Program LED is green and the Run LED of PLC is blinking, stop the PLC by moving the switch of Run/Stop from the position of On/Run to the position of Stop/Off. If the switch is on the position of Stop/Off, shift it to Run after that back to Stop to confirm the change.
4. Begin the programming software and adjust the request values of timeout as required.
5. Attach the programmer to the CPU PLC.
6. Utilize the software of programming to write, read, or validate the data. The pushbutton on the Store device of EZ Program is not utilized when executing an update with the present of programmer.
Update a CPU PLC without a Present of Programmer
With a configuration, Ethernet Global Data, program, tables, and Advanced User Parameters already saved in the Store device of EZ Program, it can be utilized to renew one or more other PLC CPUs of the similar type. All the data saved in the Store device of EZ Program will be restructured in the PLC CPU. To renew all of the data in a PLC CPU of VersaMax, follow these steps below:
1. Plug the Store device of EZ Program into the VersaMax PLC CPU port 2. If the PLC is in mode of Run when the Store device of EZ Program is linked, the Run LED blinks at a 1 Hz. This blinking specifies that the switch of Run/Stop is enabled, not considering of the switch configuration.
2. If the Run LED of PLC is blinking and the LED on the tool is green, stop the PLC by shift the switch of Run/Stop from Run/On position to Stop/Off position. If the switch is on the position of Stop/Off, shift it from Run after that back to Stop to confirm the change.
3. Depress the pushbutton on the Store device of EZ Program to begin the update. The LED on the Store device of EZ Program switches yellow and the LED of Port 2 on the PLC flickers.
4. Stay for the renew to comprehensive. Writing and reading great programs, configurations of hardware, and indication tables to or from the Store device of EZ Program may get 30 seconds or more to comprehensive.